Visual Land Impulse Istruzioni per gli Interventi Scaricare il pdf (Pagina 5)

ABOUT YOUR DETECTOR

Your IMPULSE is fairly simple to operate; however, its no-motion

design makes it operate differently from more-common, VLF,

induction-balance metal detectors. Therefore, even if you are

an experienced detector user, we strongly recommend that you

read this entire manual before starting. But if you just can’t wait,

here are some quick instructions to get you going on land.

1. Hold the coil up and away from any metal.

2. Set the tuner full counter clockwise, just before

it clicks into the “BATT TEST” position.

3. Set the VOLUME control knob to “10.”

4. Hold the search coil 1 to 2 inches above the

ground and adjust the TUNER control knob until the

audio tone can just barely be heard (usually one

or two bars on the LCD).

5. Readjust the volume control to a comfortable level,

when the search coil is passed over a large target.

6. You’re ready to go. Walk slowly and keep the coil

close to and parallel to the ground.

7. To pinpoint a target, locate the spot where the

volume and pitch of the audio signal peak. The LCD

signal-strength meter will also peak when the

center of the search coil is directly over the target.

8. To pinpoint the target more precisely, detune the

detector by readjusting the TUNER control counter

clockwise. This will reduce the sensitivity of the

search coil until only the center, or hot spot,

responds to the target.

CONDENSED OPERATING INSTRUCTIONS

13. All Metals: The IMPULSE detects all metals. It

has no “discrimination” circuitry, which drastically

reduces the ability of a pulse induction metal

detector to detect gold and silver.

14. Easy to Use: Just pick it up, turn it on and adjust

the TUNER control to the threshold level. You’re

ready to hunt.

1 2 3 4 5 6 7 8 9 10 ... 27 28

Nessun commento

Visual Land Impulse Istruzioni per gli Interventi Pagina 5